General Operating Problems - Meridian 565 Installation Manual

General operating problems

Standby point not lit
Check the following:
There is AC power connected to the socket on the rear of the
565.
The power switch on the rear panel of the 565 is turned on.
If the 565 will still not illuminate, check any fuses in your power
supply and the fuse in the inlet of the 565. If these are all intact,
contact your dealer.
Remote not working
Check the following:
The battery in the Meridian System Remote.
Remove the 500 comms connections from the 565, does it
respond now? If so, replace the connections and perform an
Auto Configure procedure; see Connecting to other Meridian
equipment, page 18.
See if the 565 is set to Not Controller in Config; see To set
other configuration options, page 27. Note that this may be
deliberate by your dealer.
54
Communications not working with
other Meridian products
Check the connections carefully.
Are you using a mix of 200 and 500 Series units?
Erratic or unexpected system
behaviour
Redo the Auto Configure process; see Connecting to other
Meridian equipment, page 18.
If this fails, the memory of the 565 may have been corrupted. If
this is suspected perform a full reset.
I am playing a Dolby Digital DVD, but
the 565 selects the Pro Logic preset
DVDs include a 2-channel Dolby Digital soundtrack, which will
use the default 2-channel preset.
Select a 6-channel soundtrack, if it is available.