Setting Up The Speaker Outputs - Meridian 565 Installation Manual

Setting up the speaker outputs

The next stage in configuring the 565 is to specify information
about each of the speakers in your layout, and adjust their
delays to time-align the system so that sounds are coincident
when they arrive at the listening position.
To time-align the system
Before setting up the speaker outputs you need to measure the
distance, in cm or inches, to each speaker from the listening
position.
As you measure each distance, write it against the
appropriate line in the diagram opposite (or a copy of it).
Measure from the ear height at the listening position to the
tweeter on each speaker (where applicable).
Then decide which speaker is furthest from the listening
position; this distance is referred to as furthest below.
28
Sub Centre
Left
Left
Side
Surround Sub
Left Rear
Right
Right
Side
Right Rear