Audio Problems - Meridian G68 Installation Manual

 
Tr o u b l e s h o o t i n g
Remote not working
Check the following:
• The battery in the MSR+.
• Remove the Comms connections from the G68 and check
whether it responds now. If so, replace the connections and
perform an Auto Configure procedure; see To connect to other
Meridian G Series, 500 Series, or 800 Series equipment , page 24.
• See if the G68 has been set up as Not Controller in the
Configuration Menu; see Configuring other settings , page 34.
Note: This may be deliberate by your dealer.
When playing a Dolby Digital DVD, the G68 selects a two-
channel preset
DVDs include a two-channel Dolby Digital soundtrack, which will
use the default two-channel preset.
• Select a six-channel soundtrack, if it is available.
Unit is overheating
Check that there is adequate ventilation around the unit.

Audio problems

Hum on analogue input
• Check the source equipment. Disconnect each source in turn.
• If the hum originates from a ground loop, an antenna or cable
supply may be the cause. In this case an antenna-lead isolator
should be fitted.
• If the G68 seems to be the cause of hum consult your dealer.
There is radio interference
The G68 is a digital audio and computing device which has been
designed to very high standards of electromagnetic compatibility.
If this equipment does cause or suffer from interference to/from
radio or television reception then the following measures should
be tried:
• Reorient the receiving aerial (or antenna) or route the antenna
cable of the receiver as far as possible from the G68 and its
cabling.
• Ensure that the receiver uses well-screened antenna cable.
• Relocate the receiver with respect to the G68.
• Connect the receiver and this product to different AC outlets.
• If the problem persists contact your dealer.