Table of Contents
Advertisement
2.7 Jumper Setup
The illustration shows how jumpers are setup. When the jumper cap is placed on
the pins, the jumper is "Short". If no jumper cap is placed on the pins, the jumper
is "Open". The illustration shows a 3-pin jumper whose pin1 and pin2 are "Short"
when a jumper cap is placed on these 2 pins.
SATA DOM Power Jumper*
(3-pin SATAPWR1)
(No. 25)
*SATAPWR1 allows you to select the internal voltage source for the SATA DOM
connected on the SATA_0 connector (No.24).
CPU PECI Mode Jumper
(3-pin PECI1)
(No. 44)
30
SATA DOM
Reserved Only
SATA Cable (Default)
CPU PECI connect to BMC
(Default)
Advertisement
Table of Contents
