Asus Terminator 2 Barebone System T2-PE1 Product Manual page 42

Power supply unit plugs
7. Connect the 4-pin power plug to the power connector of the floppy
disk drive.
8. Connect the 4-pin power plug to the power connector of the optical
drive.
9. Connect the 4-pin power plug to the power connector of the IDE hard
disk drive, or the Serial ATA hard disk drive with 4-pin power plug.
9. Connect the 15-pin SATA power adapter plug to the power connector
at the back of the SATA hard disk or optical drive, then connect the
other end (4-pin male) to a 4-pin (female) power plug from the power
supply unit.
See the Appendix for the power supply specifications.
Voltage selector Voltage selector Voltage selector
Voltage selector Voltage selector
The PSU has a 115 V/230 V voltage selector
switch located beside the power connector. Use
this switch to select the appropriate system
input voltage according to the voltage supply in
your area.
If the voltage supply in your area is 100-127 V,
set the switch to 115 V.
If the voltage supply in your area is 200-240 V,
set the switch to 230 V.
Setting the switch to 115 V in a 230 V environment will seriously
damage the system!
2 - 2 4 2 - 2 4 2 - 2 4 2 - 2 4 2 - 2 4
8 8 8 8 8
9 9 9 9 9
1 1 1 1 1
7 7 7 7 7
2
- o r - - o r -
- o r - - o r - - o r -
C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
9 9 9 9 9
1 1 1 1 1