Konica Minolta FK-502 Service Manual page 100

ERROR CODES
Code No. Category
F-code
T61
Polling transmission
F-code
T62
Polling transmission
T63
T64
T65
T66
T67
T68
T69
T70
T71
T72
T73 Transmission
T74 V34
T75 V34
T76 V34
T77
T78 Transmission
T79 Transmission
T80 Call control
T81 Call control
T82 Call control
T83 Call control
T84 Call control
T85 Call control
T86 Call control
T87
T88
T89 Control unit
T90
T91
T92
T93
T94
5-8
Contents of Error
Unsatisfactory conditions for
receive polling tx request.
Box number specified by SEP is
not valid.
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Not used
Modem response waiting T.0
(60 seconds)
No changes in the V34 modem
status
V34 signal sending error
CS2 is not turned to ON
Reserved
Codec control soft ware error
Job control soft error at trans-
mission
LOOP current detection NG
when CML is turned ON at call-
ing
Dial Tone detection NG when
CML is turned ON at calling
Answer tone (CED/DIS) waiting
timeout after dialing at calling
Busy tone detection at calling
Line control dial error
Short disconnection was
detected after LOOP current
detection at calling
Dial Tone continues after dialing
Not used
Not used
When the control unit is con-
nected, a communication error
is caused due to capacity short-
age and communication is fin-
ished.
Reserved
Reserved
Reserved
Reserved
Reserved
FK-502/Network Fax Service Manual Ver.3.0
How to correct
Bulletin board original may not be
set. Bulletin board TX is enabled only
when the bulletin board transmission
original is registered.
Bulletin board Box number from the
remote station may be incorrect.