Panorama Roof With Power Tilt; Sliding Panel; Roller Sunblinds; Synchronizing - Mercedes-Benz 2010 E-Class Sedan Operator's Manual

2010 e-class sedan
Table of Contents

Advertisement

Panorama roof with power tilt/sliding panel
194
in direction of arrow = until the tilt/sliding
sunroof is fully closed.
The tilt/sliding sunroof closes with greater
force.
If the tilt/sliding sunroof is blocked again and
opens slightly:
X
Immediately after the tilt/sliding sunroof
was blocked and has opened, pull and hold
the sunroof switch in direction of arrow
= until the tilt/sliding sunroof is fully
closed.
The tilt/sliding sunroof closes without
automatic reversal function.
G
Warning!
Pulling and holding the sunroof switch to
close the tilt/sliding sunroof immediately
after it had been blocked two times will cause
the tilt/sliding sunroof to close without any
reversal function for as long as you hold the
sunroof switch.

Synchronizing

The tilt/sliding sunroof must be synchronized
after a malfunction or if it does not open
smoothly.
!
If the tilt/sliding sunroof cannot be closed
or synchronized, contact an authorized
Mercedes-Benz Center or call Roadside
Assistance.
X
Switch on the ignition.
X
Press and hold the sunroof switch in
direction of arrow : (
tilt/sliding sunroof is fully raised at the
rear.
X
Keep holding the sunroof switch in
direction of arrow : for approximately
1 second.
X
Check the express operation feature
(
Y
page 193).
If the tilt/sliding sunroof opens and closes
completely, the roof is synchronized.
Otherwise repeat the above steps.
Y
page 193) until the

Panorama roof with power tilt/

sliding panel

Extending and retracting the roller
sunblinds
The roller sunblinds only operate with the tilt/
sliding panel closed. The front and rear roller
sunblind cannot be operated individually.
G
Warning!
When extending the roller sunblinds, make
sure no one is in danger of being injured by
the extending procedure.
The roller sunblinds are equipped with the
express operation and automatic reversal
function. If the movement of the roller
sunblinds is blocked during the extending
procedure, the roller sunblinds will stop and
retract slightly.
The extending of the roller sunblinds can be
immediately halted by releasing the roof panel
switch or, if the roof panel switch was moved
past the resistance point and released, by
moving the roof panel switch in any direction.
Roof panel switch
Retracting
:
Retracting
;
Extending
=
X
Switch on the ignition.
X
Retracting/Extending: Move the roof
panel switch to the resistance point in the
required direction of arrow :, ; or =

Advertisement

Table of Contents
loading

Table of Contents