Method 2 - Uninstalling The Lifter Actuator With The Lifter Lowered - Invacare FDX Service Manual

8.7.4.2

Method 2 - uninstalling the lifter actuator with the lifter lowered

WARNING: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
● Let a second person help you.
Requirements:
● Spring-ring pliers
● Side cutting pliers
● Cable ties
● Bent-nose pliers
● 6 mm Allen key
Note
Take careful note of the exact position of the seat. Mark the position it is mounted in, the angle,
the positions of all cables and so on. If necessary, make photographs with a digital camera.
Any modification of the adjustment of the seat affects the centre of gravity of the wheelchair.
●
Switch the electronic control system off.
The actuator module for the lifter and the tilt actuator are mounted to the front edge of the seat
frame.
●
Completely remove both knurled head screws (1) including the washers.
●
Remove the cover (2).
●
Disconnect the plug from the actuator module.
●
Open the cable clips on the underside of the seat.
●
Free up the actuator cable so that you can remove the seat.
82