8.15
Replacing the spring in the rear
Note
Invacare® recommends always replacing both springs to ensure optimum performance of the
wheelchair.
WARNING: Danger of crushing!
The wheelchair is very heavy. Danger of injury to the hands and feet!
●
Let a second person help you.
Danger of injury due to uncontrolled movement of the wheelchair!
●
Switch the vehicle's power system off (ON-/OFF key).
●
Engage the drive motors.
●
Secure the vehicle against rolling away by placing wedges under the wheels.
Requirements:
● 5 mm Allen key
● Two oblong wooden blocks, at least 14 x 14 x 30 cm
Uninstalling the suspension:
●
Lift the wheelchair on one side and have a second person place a 14 cm high wooden block
underneath the battery compartment, so that the wheels are off the ground and can rotate
freely.
●
Repeat this on the other side of the wheelchair.
●
Remove the drive wheel, as described in chapter 8.12.1.
●
Remove the front, rear and lateral covers, as described in chapter 8.1.1, 8.1.2 and 8.1.3.
●
Remove the drive wheel, as described in chapter 8.12.1.
●
Use the 5 mm Allen key to loosen and remove both screws (3).
●
Remove the black plastic stop (1).
●
Push the rear wheel cantilever arm downwards.
●
Remove the spring (2).
115