Resetting To Factory Settings; Menu; Individual Settings; Messages In The Multifunction - Mercedes-Benz 2009 CLK-Class Operator's Manual

Controls in detail
Control system
X
Press button or repeatedly until
è ÿ
the Vehicle status message memory
menu appears in the multifunction display.
If conditions have occurred causing status
messages to be recorded, the number of
messages appears in the multifunction
display.
X
Press button or k.
j
The stored messages will now be displayed
in the order in which they have occurred.
For malfunction and warning messages,
see "Vehicle status messages in the
multifunction display" ( Y page 279).
Should the vehicle's system record any
conditions while driving, the number of
messages will reappear in the multifunction
display when the SmartKey in the starter
switch is turned to position 0 or removed
from the starter switch. With KEYLESS-GO,
the number of messages will reappear when
you turn off the engine by pressing the
132
KEYLESS-GO start/stop button and open the
driver's door.
Except for high-priority messages, the vehicle
status message memory will be cleared when
you switch off the ignition.
Settings menu
Introduction
In the Settings menu there are two
functions: The function To reset, press
reset button for 3 seconds, with which
you can reset all the settings to the original
factory settings and a collection of submenus
with which you can make individual settings
for your vehicle.
The following settings and submenus are
available in the Settings menu:

Resetting to factory settings

R
( Y page 132)
Submenus in the Settings menu
R
( Y page 133)
Instrument cluster submenu
R
( Y page 134)
Time/Date submenu ( Y page 135)
R
Lighting submenu ( Y page 136)
R
Vehicle submenu ( Y page 138)
R
Convenience submenu ( Y page 139)
R
Resetting to factory settings
You can reset the functions of all submenus
to the factory settings.
For safety reasons, the function Headlamp
Mode in the Lighting submenu cannot be
reset while driving.
X
Press button or repeatedly until
è ÿ
the Settings menu appears in the
multifunction display.
X
Press the reset button in the instrument
cluster for approximately 3 seconds.
The request to press the reset button once
more to confirm appears in the
multifunction display.
X
Press the reset button once more.
The functions of all the submenus will be
reset to factory settings.