Mercedes-Benz 2009 CLK-Class Operator's Manual page 337

Front turn signal lamp bulb
X
Turn bulb socket with the bulb
3
counterclockwise and remove it.
X
Gently press onto the bulb and turn it
counterclockwise out of bulb socket 3.
X
Gently press the new bulb into bulb socket
and turn it clockwise until it engages.
3
X
Place bulb socket back into the housing
3
and turn it clockwise until it engages.
Parking and standing lamp bulb
X
Turn housing cover counterclockwise
2
and remove it.
X
Pull out bulb socket with the bulb.
6
X
Pull the bulb out of bulb socket 6.
X
Gently press the new bulb into bulb socket
6.
X
Reinstall bulb socket 6.
X
Align housing cover and turn it
2
clockwise until it engages.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X
Switch off the ignition.
X
Turn the exterior lamp switch to position
M.
X
Open the trunk.
Tail lamp unit
X
Swing the trim panel covering the
corresponding rear lights to the side.
Connector
1
Tab
2
Practical hints
Replacing bulbs
X
Disconnect electrical connector 1.
X
Pull tab in the direction of the arrow.
2
X
Remove the bulb carrier.
Bulb carrier
Brake lamp
3
Backup lamp
4
Rear fog lamp (driver's side)/tail lamp
5
Tail lamp, parking and standing lamp, side
6
marker lamp
Turn signal lamp
7
X
Depending on which bulb needs to be
replaced, gently press onto the respective
bulb and turn it counterclockwise out of its
bulb socket.
X
Gently press the new bulb into its bulb
socket and turn clockwise until it engages. Z
335