Fisher & Paykel CG302D Installation Instructions Manual page 5

1 SAFETY AND WARNINGS
Before you install the appliance, please make
sure that
the local distribution conditions (nature of
gas and pressure) and the adjustment of the
appliance are compatible. For adjustment
conditions for this appliance see 'Gas rate
summary' .
a suitable disconnection switch is incorporated in
the permanent wiring, mounted and positioned
to comply with the local wiring rules and
regulations. A means of disconnection with at
least a 3 mm air gap contact separation in all
poles must be incorporated into the fixed wiring
in accordance with the wiring rules, unless the
local wiring rules allow for alternative means.
the appliance is connected to a 220V - 240V 50Hz
(10 A) power supply only and earthed via the
power supply cable.
there is a power outlet within reach of the power
supply cable (900 mm from the centre rear of
the product). This must be accessible after
installation. The power supply cable should not
touch any metal parts.
if the power supply cable is damaged, it is
replaced only by the special cable: Part no. 534994
KIT SPARES TRMNL BLK-FLEX 11, obtainable from
authorised Fisher & Paykel Service Agents.
the supply connection point (gas shut-off valve) is
accessible after installation.
the benchtop is made of a heat resistant material.
the installation complies with all the requirements
of all current local codes and regulations.
When you install the appliance
We do not recommend you flush mount or seal
this appliance into the bench with silicone or
glue. Doing so will make future servicing difficult.
Fisher & Paykel will not be liable for any costs
associated with removing or replacing a sealed-in
appliance, nor for repairing any damage that may
be incurred by doing this.
If installed with an approved flexible hose, the
hose should not come in contact with the bottom
of the appliance or any sharp edges. Flexible hose
assemblies should be BS 699.1 certified.
Seal exposed bare edges of the cutout with an
oil-based paint or moisture-proof polyurethane to
prevent possible moisture creeping between the
cooktop trim and the benchtop.
Take extreme care not to chip, crack, or break the
top glass surfaces during installation. A heavy
metal tool or part accidentally dropped on the
glass could damage it.
5