AMX AXD-CV6 Instruction Manual page 9

Install the #4-40
machine screws
into the holes
shown below.
Screw length
depends on the
installation surface.
A - Decor
faceplate
FIG. 4 Decor-style panel installation configuration for flat /solid surfaces
.12
2.900
FIG. 5 Decor-style panel cutout dimensions for flat surface mounting
6. Test the connection by reconnecting the AXlink connector to the Central Controller. Verify that
the panel is receiving power and functioning properly to prevent repetition of the installation.
7. Disconnect the AXlink connector from the Central Controller until installation is complete.
8. Connect the data and power wiring to the rear of the touch panel.
6" Color Video Wall Panel
6.79
(BEZEL)
6.21
5.97
ZERO RADIUS REQUIRED
IN THESE 4 CORNERS.
THESE 4 HOLES ARE ONLY REQUIRED
WHEN MOUNTING UNIT TO A SOLID
SURFACE (PODIUM, DESK, ETC.).
SECURE UNIT WITH #4 SCREWS.
SUGGEST INSTALLATION OF #4-40
THREADED INSERTS AT THESE 4
LOCATIONS.
CUTOUT
FRONT BEZEL
FRONT BEZEL
B - Main AXD unit consists of
the touch panel and housing
.28 REF
4.43
5.37
(BEZEL)
#4-40 machine screw inserts (#4 screws)
used for mounting to a flat surface (provided by
installer)
Installation
Solid surface
(can include a
wall, podium, or
other level
surface)
These 4 screws
are removed
to access or
replace the
battery.
5