AMX AXD-CV6 Instruction Manual page 29

System Send_Commands (Cont.)
BRIT
Adjusts brightness
of display.
CALIBRATE
Starts the touch
panel calibration
sequence.
CLOCK
Sets the time and
date.
CURSOR
Turns the cursor
display On or Off if
the touch device
has a cursor.
DBEEP
Gives a double
beep output.
ILEV
Inverts the joystick
axis.
6" Color Video Wall Panel
Syntax:
"'BRIT-<level>'"
Variable:
level = 1 - 8 (1 = minimum; 8 = maximum)
Example:
SEND_COMMAND TP,"'BRIT-8'"
Sets to highest brightness level.
Syntax:
"'CALIBRATE'"
Example:
SEND_COMMAND TP,"'CALIBRATE'"
Starts the calibration operation on the touch panel.
Syntax:
"'CLOCK <mm-dd-yy> <hh:mm:ss>'"
Variables:
mm = 01 - 12, dd = 01 - 31, yy = 00 - 99
hh = 00 - 23, mm = 00 - 59, ss = 00 - 59
Example:
SEND_COMMAND TP,"'CLOCK 02-08-98 19:16:00'"
Sets the touch panel's date to February 8, 1998, and time to 7:16 p.m.
Syntax:
"'CURSOR <OFF/ON>'"
Variables:
Off = 0 and On = 1
Example:
SEND_COMMAND TP,"'CURSOR 0'"
Turns the cursor display Off.
This command only works if the Double Beep value in the Protected Setup page is set to
On.
Syntax:
"'DBEEP'"
Example:
SEND_COMMAND TP,"'DBEEP'"
Double beeps the panel.
Syntax:
"'ILEV <joystick axis to invert>'"
Variables:
joystick axis to invert =
0 : Normal G3 joystick (origin: top left)
1 : Invert horizontal axis (origin: top right)
2 : Invert vertical axis (origin: bottom left)
3 : Invert both axes (origin: bottom right)
Example:
SEND_COMMAND TP,"'ILEV 3'"
Inverts the joystick axis to move the origin to another corner.
Programming
25