Charging T He Bat T Ery - Datamax APEX 3 User Manual

1 .2 .2 Ch a r gin g t h e Ba t t e r y

Plug t he bat t ery charger adapt er out put cable int o t he bat t ery charger connect or as shown
in Figure 3.


Plug t he bat t ery charger adapt er int o t he appropriat e AC line volt age socket .

The Yellow / Am ber charging LED will illum inat e indicat ing t hat t he bat t ery is charging.

The bat t ery will be fast charged and, aft er approx. 180 m inut es, t he LED will t urn off.
To rem ove t he bat t ery cart ridge, open t he bat t ery door and t ip t he bat t ery out of t he
.
print er
Not e: To ensure a full charge do not operat e t he print er while charging.
Not e: The wall m ount ed charger is Class I I equipm ent (
com ply wit h m ost int ernat ional st andards. The wall m ount ed charger is not supplied wit h
plugs for use in Korea.

The wall m ount ed charger has t he follow ing specificat ions:
M ode l
I n pu t Volt a ge / Cur r e n t
I n pu t Fr e qu e n cy
Ou t pu t V olt a ge / Cur r e n t (
Do not use a charger not approved by Datamax-O'Neil for use with the APEX 3. Use of
an unapproved charger could damage the battery pack or the printer and will void the
warranty.
The battery terminals are well recessed inside the printer. Do not allow them to contact
conductive material since this may create a short circuit which could cause injury or
start a fire.
FI GURE 3 : CH ARGI N G TH E BATTERY CARTRI D GE
)
. Mult iple plug configurat ions
APEX 3
100- 240 VAC/ 0.55A
50- 60 Hz
10VDC/ 2.4A
)
4