AT&T MDW 9000 Installation Manual page 13

Read and understand all instructions in this booklet before using
this product.
Observe all warnings and instructions marked on the product.
Unplug this product from wall outlets and telephone jacks before
cleaning. Clean exposed parts with a soft, damp cloth. Do not use
liquid or aerosol cleaners.
Do not use the product near water or when you are wet. If product
comes in contact with any liquids, unplug the power cord and
telephone line cords immediately. Do not plug the product back
in until it has dried thoroughly.
If you suspect a gas leak, report it immediately, but use a telephone
away from the area in question. The telephone's electrical contacts
could generate a tiny spark. While unlikely, it is possible that this
spark could ignite a heavy concentration of gas. This product is not
approved for use in areas labeled by the Occupational Safety and
Health Administration (OSHA) as "explosive environments." Only
"Explosive Atmosphere Telephones" may be used in such hazard-
ous environments.
Never push objects of any kind into this product through housing
slots, since the objects may touch hazardous voltage points or short
out parts that could result in a risk of electric shock. Never spill liquid
of any kind on the telephone.
Install this product securely on a stable surface. Damage may result
if the product falls.
Install this product in a protected location where no one can step
on or trip over power cords and telephone line cords. Do not
place objects on the cords that may cause damage or abrasion.
Use only the Model # PIDB-270 power supply shipped with this
product for the Battery Charger or radio module.
Use only the Model # SW109 power supply shipped with the
carrier assembly.
Use only the correct power source. If you are not sure of the power
supply to your location, consult your local power company.
9