AT&T MDW 9000 Installation Manual page 17

The radio module/carrier assembly should never be installed above
a drop, suspended level ceiling.
The radio module/carrier assemly should not share the same
power line as equipment with microprocessors such as answering
machines, personal computers, and fax machines; or electromag-
netic equipment such as electric motors
The radio module/carrier assembly should not be within 6
feet (2m) of equipment with microprocessors such as an-
swering machines, personal computers, and fax machines;
electromagnetic equipment such as electric motors; or
electrical main power feeds, junction boxes, circuit-breaker
panels, or fuse boxes.
Install a single radio module within 3 feet (1 m) of either side of,
and within 6 to 8 feet (2 to 2.6 m) above, a properly grounded
3-prong electrical outlet that is not controlled by an on/off switch.
Install the carrier assembly within 15 feet (5 m) of either side of,
and within 6 to 8 feet (2 to 2.6 m) above, a properly grounded
3-prong electrical outlet that is not controlled by an on/off switch.
If your communications system uses an uninterruptable power
supply, such as a backup generator, be sure to connect the radio
module/carrier assembly to that power supply.
Installing a single radio module on a shelf or desk is not recom-
mended, because it greatly reduces the range and quality of the
transmission.
Go to one of the following sections:
"Installing a Single Radio Module"
"Installing the Carrier Assembly on a Wall"
"Installing the Carrier Assembly on a Shelf or Desk"
NOTE:
The following illustrations depict PARTNER system hardware.
Your hardware may differ from that which is shown.
13