3-Thread Serging - ELNA 664 Pro Instruction Manual

3-Thread Serging

Using the needle on the right only
(for stitch numbers 6-9)
When you use the right needle, the standard sewing
width is 3.5 mm.
The illustration on the left shows you how to thread
the needle.
Note:
Tighten the needle clamp screw on the side that is
not being used to prevent losing the screw.
1
Changeable thread guide: 3/4
1
Using the needle on the left only
(for stitch numbers 10-12)
When you use the left needle, the standard sewing
width is 5.7 mm.
The illustration at left shows you how to thread the
needle.
1
Changeable thread guide: 3/4
1
37