3. Press CH- to highlight TUNER MODE and press VOL+ to select Cable or Air (antennae).
4. Press CH- to highlight AUTO SCAN.
If you have Cable selected, set Cable System to AUTO.
5. Press VOL+ to highlight START TO SCAN and then VOL+ again to start the scan.
The scan is searching for channel signals within range or available through cable, and when the scan is
complete a list is created of channels with signals strong enough to recognize. Some channels that are added
to the list still may not have signals strong enough for clear viewing.
When you use the CH+ and CH- buttons to scroll through the channels, the only the channels that will be
displayed are those on the scan list. If you want to view a channel that is not on the scan list, you can use the
number pad and manually enter the channel number you want to view. (Refer to Browsing Shortcuts on page
30 for more information.)
Note: The KTC's tuner is designed for HDTV therefore requires a stronger signal than normal TVs. If you
cannot achieve that signal level with your antenna or cable, your KTC might lose picture or sound.
Not all broadcasts are in High Definition (HD). Refer to your local broadcasting stations for more
information.
When the scan finishes you can begin to watch TV.
On Screen Display (OSD) Menu
You can adjust most of the OSD menu options by using either the remote control or the side panel buttons on
your KTC.
OSD Menu Options Overview
VIDEO
Change the screen picture settings for all ports: Tint, Contrast, Sharpness, Brightness, Saturation,
and Color Temperature
AUDIO
Change sound settings for all ports: Treble, Bass, and Balance
21