Connecting Speakers To The Ktc; Power On Your Ktc; No Database; Proceed With Auto Scan - Pandigital PANTV1512 Kitchen Technology Center User Manual

Connecting Speakers to the KTC

The KTC has built-in speakers, but you can also connect external speakers or an external amplifier, depending on
the model of your KTC. Some models come with an external audio jack. If your KTC has an audio jack, you can
plug speakers into the audio jack located on the right side of the KTC (cable not included).

Power on your KTC

After you have connected the appropriate cables and power cord, press the POWER button on the remote control
or the power button on the KTC, located in the middle of the speaker bar on the bottom of the screen.
The power button on the KTC has an indicator light that lights red when the KTC is off and lights blue when on.
The remote control sensor is also located in the KTC's power button. When using the remote control, point
directly towards the sensor for best response.
WARNING: The KTC defaults to the TV mode when shipped from the factory. The
first time you power it on, you may receive the following messages:

'No Database'

If you are connected to cable or a TV antenna, and the message 'No Database' appears, the KTC is
not receiving a strong enough signal for the current channel to be displayed. Follow the Initial Tuner
Setup instructions on page 20 to perform the necessary auto channel scan.

'Proceed with Auto Scan'

If you are not connected to cable or a TV antenna, the first time you power the KTC on, the unit will
display 'Proceed with Auto Scan' and/or 'No Database' messages. Press SOURCE on the remote
control or side panel buttons, use the arrows to highlight DPF, and then press ENTER. The KTC will now
be in the Digital Photo Frame (DPF) mode, and will remain in the DPF mode until you change the
SOURCE at a later time.

The Side Panel Control Buttons

The KTC has a set of buttons located on the side panel of the KTC which allow you to control many of the On
Screen Display (OSD) functions.
From top to bottom:
1. SOURCE Select the sources of the KTC features (TV, AV, S-Video, Component, DPF, HDMI, and PC).
2. VOL+ Increases the TV's volume. Also functions as the RIGHT scroll button when the OSD menu is
active.
3. VOL– Decreases the TV's volume. Also functions as the LEFT scroll button when the OSD menu is
active.
4. CH+ Changes the TV channel upward. Also functions as the UP scroll button when the OSD menu
is active.
13