Table of Contents
Advertisement
1.7
System memory
1.7.1
Overview
The motherboard comes with four Double Data Rate 2 (DDR2) Dual Inline
Memory Modules (DIMM) sockets.
A DDR2 module has the same physical dimensions as a DDR DIMM but has
a 240-pin footprint compared to the 184-pin DDR DIMM. DDR2 DIMMs are
notched differently to prevent installation on a DDR DIMM socket.
The figure illustrates the location of the DDR2 DIMM sockets:
P5ND2 SE
P5ND2 SE 240-pin DDR2 DIMM Sockets
Channel
Channel A
Channel B
1.7.2
Memory configurations
You may install 256 MB, 512 MB, 1 GB, 2 GB and 4 GB unbuffered non-ECC
DDR2 DIMMs into the DIMM sockets.
•
•
•
•
1-16
R
Sockets
DIMM_A1 and DIMM_A2
DIMM_B1 and DIMM_B2
For dual-channel configuration, the total size of memory module(s)
installed per channel must be the same
(DIMM_A1 + DIMM_A2 = DIMM_B1 + DIMM_B2).
Always install DIMMs with the same CAS latency. For optimum
compatibility, it is recommended that you obtain memory modules from
the same vendor. Refer to the DDR2 Qualified Vendors List on the next
page for details.
If you install four 1GB memory modules, the system may only recognize
less than 3 GB because the address space is reserved for other critical
functions. This limitation appears on Windows
system which does not support Physical Address Extension (PAE).
If you install Windows
less than 3GB is recommended.
®
XP 32-bit operation system, a total memory of
Chapter 1: Product introduction
®
XP 32-bit operation
Hide quick links:
Advertisement
Table of Contents
