System Memory - Asus PRIME H610I-PLUS Manual

1.4

System memory

This motherboard comes with two Double Data Rate 5 (DDR5) Dual Inline Memory Module
(DIMM) sockets. The figure illustrates the location of the DDR5 DIMM sockets:
A DDR5 memory module is notched differently from a DDR, DDR2, DDR3, or DDR4
module. DO NOT install a DDR, DDR2, DDR3, or DDR4 memory module to the DDR5 slot.
•
•
•
•
•
•
Recommended memory configurations
DIMM_A
1-10
E22166_PRIME_H610I-PLUS_UM.indd 10 E22166_PRIME_H610I-PLUS_UM.indd 10
DIMM_A
DIMM_B
You may install varying memory sizes in Channel A and Channel B. The system
maps the total size of the lower-sized channel for the dual-channel configuration. Any
excess memory from the higher-sized channel is then mapped for single-channel
operation.
You may install 8 GB, 16 GB, 24 GB, 32 GB and 48 GB unbuffered and Non-ECC
DDR5 DIMMs into the DIMM sockets.
The default memory operation frequency is dependent on its Serial Presence Detect
(SPD), which is the standard way of accessing information from a memory module.
Under the default state, some memory modules for overclocking may operate at a
lower frequency than the vendor-marked value.
For system stability, use a more efficient memory cooling system to support a full
memory load.
Always install DIMMs with the same CAS latency. For optimal compatibility, we
recommend that you install memory modules of the same version or date code (D/C)
from the same vendor. Check with the retailer to get the correct memory modules.
Supported memory types, data rate (speed), and number of DRAM modules vary
depending on the CPU and memory configuration, for more information please refer
to CPU/Memory Support list under the Support tab of product information site or visit
https://www.asus.com/support/.
DIMM_B
Channel Sockets
Channel A DIMM_A
Channel B DIMM_B
DIMM_A
DIMM_B
Chapter 1: Product Introduction
2023/8/8 14:39:17 2023/8/8 14:39:17