Care And Maintenance; Cleaning The Filters; Leaving The Machine Unused For Extended Periods - Hotpoint FDW 70 Instruction Booklet

Care and maintenance

EN
12

Cleaning the filters

The filters remove food residue from the water used
in the wash cycle: to obtain the best results from
each wash, they should be cleaned.
Clean the filters regularly.
After cleaning check that the filter assembly has
been replaced correctly.
The dishwasher should not be used without
filters.
1. Remove the filters by pulling the handle upwards.
2. Clean the filters:
rinsing them under running water.
in an anti-clockwise direction).
Use a small non-metallic brush to clean these parts.
3. Reconstruct the filter assembly and replace it in
the correct position, following movements 1 and 2 as
shown in the figure, until it clicks into place.
Leaving the machine unused for
extended periods
• Run a wash cycle when the dishwasher is empty.
• Unplug the appliance and disconnect the water
supply.
• Leave the door of the appliance ajar.
*
Only available in selected models.
• after every wash
cycle, remove the
largest pieces of
residue from
semicircular plate A
and glass B (these
may be removed by
pulling the handle) by
• The entire filter
assembly should be
cleaned thoroughly
once a month: this
includes the
semicircular plate A,
the glass B and the
cylinder C (this may be
removed by turning it