How To Add Automatic Transmission Fluid - Chevrolet 2010 Aveo Series Owner's Manual

Then, without shutting off the engine, follow these
steps:
1. Locate the automatic transmission dipstick
which is located toward the front of the engine
compartment, near the power steering fluid
reservoir.
See Engine Compartment Overview on page 6 14
for more information on location.
2. Pull out the dipstick and wipe it with a clean rag or
paper towel.
3. Push the dipstick back in all the way, wait
three seconds, and then pull it back out again.
4. Check both sides of the dipstick. The fluid should
be between MIN (A) and MAX (B) mark of the hot
area of the dipstick.
5. If the fluid level is in the acceptable range, push
the dipstick back in all the way.
6-22
How to Add Automatic Transmission
Fluid
Refer to the Maintenance Schedule to determine what
kind of transmission fluid to use. See Recommended
Fluids and Lubricants on page 7 11.
If the fluid level is low, add only enough of the proper
fluid to bring the level into the area between the
two dimples in the hot range on the dipstick.
1. Pull out the dipstick.
2. Using a long-neck funnel, add enough fluid at the
dipstick hole to bring it to the proper level.
It does not take much fluid, generally less than
one pint (0.5 L). Do not overfill.
Notice: Use of the incorrect automatic transmission
fluid may damage the vehicle, and the damages may
not be covered by the vehicle's warranty. Always
use the automatic transmission fluid listed in
Recommended Fluids and Lubricants on page 7 11.
3. After adding fluid, recheck the fluid level as
described under How to Check Automatic
Transmission Fluid earlier in this section.
4. When the correct fluid level is obtained, push the
dipstick back in all the way.
I n f o r ma t i o n P r o v i d e d b y :