NETGEAR Wireless Router Setup Manual page 16

NETGEAR Wireless Router Setup Manual
Figure 3-4: Verify the connections according to the status lights on the wireless router
Check the wireless router status lights to verify the following:
d.
• Power: The power light should turn solid green. If it does not, see
Tips" on page
• Test: The test light should turn off after completing the power on self test diagnostic. If
it does not, see
• Internet: The Internet port light should be lit. If not, make sure the Ethernet cable is
securely attached to the wireless router Internet port and the modem, and the modem
is powered on.
• Wireless: The wireless light should be off until after the router is configured.
• LAN: A LAN light should be lit. Green indicates your computer is communicating at
100 Mbps; yellow indicates 10 Mbps. If a LAN light is not lit, check that the Ethernet
cable from the computer to the router is securely attached at both ends, and that the
computer is turned on.
3. U S
SE THE MART
From the Ethernet connected PC you just set up, open a browser such as Internet Explorer
a.
or Netscape® Navigator.
3-4
3-7.
"Troubleshooting Tips" on page
W
IZARD TO CONFIGURE THE WIRELESS ROUTER
August 2004
"Troubleshooting
3-7.
Connecting the Router to the Internet