Before You Proceed; Onboard Led - Asus Motherboard M2N-MX SE PLUS User Manual

1.4

Before you proceed

Take note of the following precautions before you install motherboard components
or change any motherboard settings.
•
•
•
•
•

Onboard LED

The motherboard comes with a standby power LED that lights up to indicate
that the system is ON, in sleep mode, or in soft-off mode. This is a reminder
that you should shut down the system and unplug the power cable before
removing or plugging in any motherboard component. The illustration below
shows the location of the onboard LED.
M2N-MX SE PLUS Onboard LED
1-6
Unplug the power cord from the wall socket before touching any
component.
Use a grounded wrist strap or touch a safely grounded object or a metal
object, such as the power supply case, before handling components to
avoid damaging them due to static electricity
Hold components by the edges to avoid touching the ICs on them.
Whenever you uninstall any component, place it on a grounded antistatic
pad or in the bag that came with the component.
Before you install or remove any component, ensure that the ATX power
supply is switched off or the power cord is detached from the power
supply. Failure to do so may cause severe damage to the motherboard,
peripherals, and/or components.
R
M2N-MX SE PLUS
SB_PWR
ON OFF
Standby Powered
Power
Off
Chapter 1: Product introduction