Subaru LEGACY Service Manual page 55

D: ASSEMBLY
1) Attach stop light switch, etc. to pedal bracket
temporarily.
2) Clean inside of bores of clutch pedal and brake
pedal, apply grease, and set bushings into bores.
3) Align bores of pedal bracket, clutch pedal and
brake pedal, attach brake pedal return spring and
clutch pedal effort reducing spring (vehicle with hill
holder), and then install pedal bolt.
NOTE:
Clean up inside of bushings and apply grease be-
fore installing spacer.
Tightening torque:
T: 29 N·m (3.0 kgf-m, 21.7 ft-lb)
T
4) Set brake pedal position by adjusting position of
stop light switch.
Pedal position: L
LHD: 126.4 mm (4.98 in)
RHD: 154.9 mm (6.10 in)
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
BRAKE PEDAL
BR-00102
T
BR-00181
BR-53
E: INSPECTION
1) Move brake and clutch pedal pads in the lateral
direction with a force of approximately 10 N (1 kgf,
2 lb) to ensure pedal deflection is in specified
range.
CAUTION:
If excessive deflection is noted, replace bush-
ings with new ones.
Deflection of brake and clutch pedal:
Service limit
5.0 mm (0.197 in) or less
( 1 )
(1) Clutch pedal
(2) Brake pedal
(1) Brake pedal
BRAKE
( 2 )
BR-00104
( 1 )
BR-00105