Table of Contents
Troubleshooting
Related Manuals for Razor iMod
Summary of Contents for Razor iMod
- Page 1 *The iPod product name is used for identification purposes only. iPod is a registered trademark of Apple Inc. Owner’s Manual Owner’s Manual Read and understand this entire manual before riding! Item Number: iMod 15130699...
-
Page 2: Table Of Contents
USING THE CHARGER Do not touch the motor on your iMod when in use as it can become very hot. The charger supplied with the iMod should be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage, Refer to the section on safety for additional warnings. -
Page 3: Before You Begin
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during WARNING: shipping. Because the iMod was 95 percent assembled and packed at the factory, there should not be any problems, DO NOT USE NON-RAZOR even if the box has a few scars or dents. -
Page 4: Assembly And Set-Up
ASSEMBLY AND SET-UP q Charging the Battery WARNING: Your iMod may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use. Rechargeable batteries are only to • Initial charge time: 18 hours • Run time: up to 40 minutes be charged under adult supervision. -
Page 5: Adjusting The Brakes
Practice in an open area free from obstacles until you are familiar with Check the Razor web site for any updates on the latest repair and maintenance procedures. the brake function. Avoid skidding Turn power switch off before conducting any maintenance procedures. - Page 6 If you decide to use such an air supply to inflate your iMod tires, first make sure the pressure gauge is working, then use very short bursts to inflate to the correct PSI. If you inadvertently over-inflate the tire, release the excess pressure immediately.
-
Page 7: Repair And Maintenance
REPAIR AND MAINTENANCE q Chain and Rear Tire Replacement Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. With a Phillips screwdriver, With a 8mm wrench, loosen the With two 10mm wrenches, remove the screws that secure the brake cable anchor and loosen brake housing anchor and chainguard. -
Page 8: Replacing The Fuse
The transformer/charger supplied with the iMod should be regularly examined for damage to the cord, plug, enclosure and other parts, and, in the event of such damage, the iMod must not be charged until it has been repaired or replaced. -
Page 9: Troubleshooting Guide
Check all connections. Make sure the charger is tightly plugged into the charging port on the iMod, and that the charger is plugged into the wall. Make sure power flow to the wall outlet is on. Charger is not working You may check to see if your charger is working by using a volt meter or asking your local Razor authorized service center to test your charger for you. -
Page 10: Troubleshooting Guide
Apply a lubricant such as 3 in 1 Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. -
Page 11: Imod Parts
POCKET MOD IMOD PARTS Keep your Pocket Mod running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) Front Wheel Complete Handlebar Grip (Right/Left) -
Page 12: Imod Parts
POCKET MOD IMOD PARTS... - Page 13 SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
-
Page 14: Safety Reminders
Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.