Motion Detection - Siemens CCMS2010-IRW User Manual

Camera settings

12.3.12 Motion Detection

44
Siemens AB
Security Products
The Motion Detection setting can be found under this path: System> Motion De-
tection.
Motion Detection function allows detecting suspicious motion and triggering alarms
when motion volume in the detected area reaches / exceeds the determined sensi-
tivity threshold value.
The function supports up to 4 sets of Motion Detection settings. Settings can be
chosen from the drop-down menu beside <Motion Detection>. In each set of set-
ting, there is a Motion Detection Window (the red frame shown in the figure be-
low) displayed on the Live Video Pane. The Motion Detection Window is for defin-
ing the motion detection area. To change the size of the Motion Detection Window,
move the mouse cursor to the edge of the window and draw it outward / inward. To
shift the window to the intended location, move the mouse cursor to the center of
the window and click and drag.
Users can configure up to 10 sets of Motion Detection Windows in each set of Mo-
tion Detection setting. Click on the <add> button under the Live Video Pane to add
a Motion Detection Window. To cancel a Motion Detection Window, move the
mouse cursor to the selected window, and click on the <delete> button.
If Motion Detection function is activated, the pop-off window (Motion) with indica-
tion of motion will be shown.
When motion is detected, the signals will be displayed on the Motion window as
shown below. Motion is detected by comparing sampling pixels in the detection ar-
eas of two consecutive live images.
Motion Detection
In each set of Motion Detection setting, the default setting for the Motion Detection
function is <Off>. Enable the function by selecting <On>. Users can also activate
the function according to the schedule previously set in the <Schedule> setting
page. Select <By schedule> and click <Please select...> to choose the desired
05.2014