Upnp - Siemens CCMS2010-IRW User Manual

Camera settings

12.3.5 UPnP

38
Siemens AB
Security Products
Traps for SNMP v1 / v2 / v3
Traps are used by the IP Camera to send massages to a management system for
important events or status changes.
 Enable Traps
Check the box to activate trap reporting.
 Trap address
Enter the IP address of the management server.
 Trap community
Enter the community to use when sending a trap message to the management
system.
Trap Option
 Warm Start
A Warm Start SNMP trap signifies that the SNMP device, i.e. IP Camera, performs
software reload.
Click on <Save> when finished.
The UPnP setting can be found under this path: System> Network> UPnP.
UPnP Setting
 Enable UPnP
When the UPnP is enabled, whenever the IP Camera is presented to the LAN, the
icon of the connected IP Cameras will appear in My Network Places to allow for di-
rect access.
NOTE: To enable this function, please make sure the UPnP component is installed
on the computer..
 Enable UPnP port forwarding
When the UPnP port forwarding is enabled, the IP Camera is allowed to open the
web server port on the router automatically.
NOTE: To enable this function, please make sure that the router supports UPnP
and it is activated.

Friendly name
Set the name for the IP Camera for identity.
Click on <Save> when finished.
05.2014