To replace the component, reverse the removal procedure.
Full-height half-length PCIe riser board and cage
To remove the component:
Power down the server (on page 29).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
Disconnect all cables connected to existing expansion boards.
5.
Remove the PCI riser cage (on page 31).
6.
Remove any existing expansion board from the riser board
7.
Remove the riser board from the cage.
8.
("Access
panel" on page 36).
("Expansion
board" on page 54).
Removal and replacement procedures 57