Static Route List - TP-Link Archer C50 User Manual

There are two submenus under the Advanced Routing menu as shown in Figure 4-87: Static
Route List and System Routing Table. Click any of them, and you will be able to configure the
corresponding function.
4.16.1

Static Route List

Choose menu "Advanced Routing → Static Route List", and then you can configure the static
route in the next screen (shown in Figure 4-88). A static route is a pre-determined path that
network information must travel to reach a specific host or network.
To add static route entries:
1. Click Add New shown in Figure 4-88, you will see the following screen.
2. Enter the following data:
Destination IP Address - The Destination IP Address is the address of the network or

host that you want to assign to a static route.
Subnet Mask - The Subnet Mask determines which portion of an IP Address is the

network portion, and which portion is the host portion.
Gateway - This is the IP Address of the gateway device that allows for contact between

the router and the network or host.
3. Select Enabled or Disabled for this entry on the Status drop-down list.
Archer C50
Figure 4-88 Static Route
Figure 4-89 Add or Modify a Static Route Entry
AC1200 Wireless Dual Band Router
- 99 -