Table of Contents
Advertisement
THE REMOTE CONTROL
Your remote control has been designed to fit the natural contours of your hands so that it is easier to use. It
works off three long-life lithium batteries.
It can control two vehicles separately. Up to four remote controls can be assigned to your vehicle. See
your dealer for replacement batteries or additional remote controls.
NOTE: The range of your remote control can be affected by a weak battery, interference from nearby metal
structures, hydro poles, or crowded parking lots.
USING YOUR REMOTE CONTROL
Your remote control can transmit on two different channels,
allowing control of two separate vehicles.
Only the "Panic" command is transmitted on both channels
simultaneously.
Each command being transmitted is confirmed by both an
audible and a visual signal (LED indicator).
CHANNEL 1 :
To transmit a command
on channel 1, press
desired button for two
seconds.
A command will not be executed if you do not press button long enough.
Only one command will be transmitted even if a button is pressed for more than two seconds except for the
Stop button, that will send a Panic command if hold more than 4 seconds.
The remote control supplied in the kit may differ from the one illustrated above.
BATTERY REPLACEMENT
Your remote works off three 3-volt lithium CR-2016 batteries or
equivalent.
We strongly recommend that you keep a replacement set in
your glove compartment.
To replace the batteries, remove screw on back of remote
case, remove old batteries and replace with new ones. Make
sure that batteries point the right way; see illustration opposite.
CHANNEL 2 :
To transmit a command on channel 2, press desired button, then
as soon as a tone is heard or LED flashes once, release the button
for a moment then press it again and hold it down for two seconds.
Start
Lock / Arm
Trunk
LED
Stop
Panic
Unlock / Disarm
3
Advertisement
Table of Contents
