Table of Contents
Advertisement
INDICATOR LIGHT
Indicator light flashes a specific number of times (see table below) to indicate different alarm conditions
when arming and disarming the system.
It can also act as a deterrent if installed in a place visible from outside the vehicle.
DURING ARMING Indicator flashes codes for zones in violation (e.g. at least one door is opened).
Only one code is shown at a time. If more than one zone is in violation during arming, code changes when
zone shown is corrected (example: door closed).
DURING DISARMING Indicator flashes code for last zone that generated the alarm condition.
Code is shown when you press
This code is repeated until you apply the brakes.
The following table shows the meaning of zone codes (number of flashes).
ZONE CODES
FLASHES
ZONE INDICATED
1
System is armed.
2
A door is/was open.
3
Hood is/was open.
4
Alarm condition is/was detected on shock sensor input.
5
Key is/was in ignition position (IGN).
Alarm condition is/was detected on additional sensor input
6
Additional sensor monitors status of ..................................................................
7
Loss of power (+12V battery supply was removed).
8
Alarm status is/has been detected on pre-shock sensor input.
Indicator can show two other conditions:
CONSTANT DIM LIGHT
RAPID FLASHES
SECONDARY FUNCTIONS
ANTI-LOCK
When connected to ignition key cylinder, this function prevents system from locking the doors during
automatic rearming if key is in the ignition.
It can also be connected to a switch to select automatic locking as ACTIVE or INACTIVE.
TEMPORARY VALET MODE (ALARM)
This mode is used to cancel automatic rearming for an indefinite period of time.
You will find this mode useful when fuelling up or working on your vehicle.
To activate Temporary Valet Mode, press
rapidly).
When light stops flashing, it confirms that Temporary Valet Mode has been activated.
To cancel this mode, place ignition key in "RUN" position then remove it; passive rearming is reactivated
when you open a door.
You can also arm the system using the remote, which cancels Temporary Valet Mode.
button.
Indicates that alarm is permanently disarmed.
See "VALET MODE" on page 12.
Indicates that system is in rearming cycle.
See "PASSIVE REARMING" and "SEMI-PASSIVE REARMING" on
page 14.
button during rearming cycle (indicator light flashes
11
Advertisement
Table of Contents
