Other Commands - AstroStart QS-5A User Manual

TRUNK RELEASE
Press button. Trunk is released and parking lights flash three times to confirm command has been
received.
Trunk cannot be released if ignition key is in "ON" position.
Furthermore, if alarm is armed and system is not equipped with an additional sensor capable of detecting
trunk release (optional equipment not included), opening of trunk with remote control will not be possible.
In this case, parking lights flash once to confirm that command has been received but trunk could not be
released.
If you are not sure you have received confirmation, repeat command. System will repeat confirmation as
often as you wish.
Remember to rearm alarm after trunk is closed ("Lock" command).
S
YSTEM EQUIPPED WITH AN ADDITIONAL SENSOR
If your system is equipped with a sensor designed to monitor status of trunk (added at time of installation),
parking lights will flash three times to confirm command was received. When trunk is released, 3 chirps are
emitted to warn that alarm will not take into account the status of this zone or the shock sensor's zone for
the next 5 minutes. If you do not release trunk within 10 seconds, the system will rearm trunk
automatically.
The timer is reset each time the command is repeated, which allows for a new 5-minute period to close the
trunk lid.
The system will sound a chirp when trunk is closed to confirm it has been rearmed. If trunk is open for
more than 5 minutes, the system switches to alarm status.
AUTOMATIC LOCK/UNLOCK
Programmable as Active or Inactive during installation.
This function locks the doors when ignition key is in "ON" position, engine is running and brakes are
applied. Doors are unlocked when key is turned from "ON" to "OFF" or when Continuous Mode is
activated.
If "Unlock" function is set to unlock only driver's door on the first command, the "Automatic Unlock" function
will unlock driver's door only. If dome light is connected to system, it is activated when an automatic unlock
occurs.
This function is : Active

OTHER COMMANDS

ANTITHEFT (CIRCUIT DISABLER)
Programmable as Active or Inactive during installation.
Your Remote Starter is equipped with an Antitheft system. This system consists of an output that controls a
relay that disables all circuits required to operate your vehicle (optional connection).
Two types of Antitheft can be use:
"PASSIVE ARMING" TYPE ANTITHEFT
This type of Antitheft system arms automatically when ignition key is turned from "ON" to "OFF" and
remains "OFF" for one minute. It can also be armed manually by sending a "Lock" command (unless
ignition key is in "ON" position).
D
ISARMING
Antitheft system is disarmed for one minute when you send "Unlock" command.
If ignition key is not turned to "ON" position within one minute, system automatically rearms, thus
preventing an intruder from starting your vehicle, even with the ignition key.
It can be connected so that horn sounds if an intruder tries to start your vehicle when it is in the active
state.
14
Inactive
.
.