Integrated Peripherals - ECS 945GZT-M Manual

34

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Onboard IDE Controller
Onboard PCI S-ATA Controller
USB Functions
Legacy USB Support
Audio Controller
Onboard LAN Function
Onboard LAN Boot ROM
Serial Port1 Address
Serial Port2 Address
Serial Port2 Mode
Parallel Port Address*
Parallel Port Mode*
ECP Mode DMA Channel*
Parallel Port IRQ*
* Stands for optional item.
Onboard IDE Controller (Enabled)
Use this item to enable or disable the onboard IDE interface.
Onboard PCI S-ATA Controller (IDE)
Use this item to enable or disable the onboard PCI SATA controller.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto allows the
system to detect the presence of USB device at startup. If detected, the USB controller
legacy mode is enabled. If no USB device is detected, the legacy USB support is disabled.
Audio Controller (Enabled)
Use this item to enable or disable the onboard audio controller.
OnBoard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network add-in
card with a remote boot ROM installed.
Serial Port1/2 Address (2F8&IRQ3/3F8&IRQ4)
Use this item to enable or disable the onboard COM1/2 serial port, and to assign a port
address.
Serial Port2 Mode (Normal)
If Serial Port 2 Address is not disabled, it allows you to set the Serial Port 2 Mode.
Parallel Port Address (378)(optional)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Integrated Peripherals
Enabled
IDE
Enabled
Enabled
Enabled
Enabled
Disabled
2F8&IRQ3
3F8&IRQ4
Normal
378
EPP+ ECP
DMA3
IRQ7
: Move Enter : Select
+/-/: Value
F1:General Help F9: Optimized Defaults
Using BIOS
Help Item
DISABLED: disables
the integrated IDE
Controller.
ENABLED: enables
only the Primary IDE
Controller.
F10: Save and Exit
ESC: Exit