Troubleshooting; The Machine Will Not Start; The Machine Loses All Power During A Program; Drying Takes Too Long - Asko T744C W Operating Instructions Manual

Troubleshooting

The machine will not start

Check:
• that the door is properly closed.
• that the main power switch is on.
• that any plug is connected.
• that the house fuses or circuit breaker have
not been tripped.
• that the overheating cut-out has not been
triggered.
The machine loses all power
during a program
The overheating cut-off shuts off the tumble
dryer if the temperature is too high, caused by
lint clogging the lint filter, for instance.
• Clean the lint filter.
• Check that the condenser is clean. Clean it
if necessary. See the Care and maintenance
instructions chapter.
• Wait until the machine has cooled, then try
starting it. If it still does not start: Call the
Customer Care Center.

Drying takes too long

• Check that the lint filter is not blocked. See the
Care and maintenance instructions chapter.
• Check that the condenser is not blocked.
See the Care and maintenance instructions
chapter.
• Prolonged drying times may also be due to
the tumble dryer being located in a confined
area or in a room that is too small, causing the
air to become too hot.
• Make sure that the tumble dryer has access
to more cold air, open doors and/or windows,
for example.

Error messages

L1 flashes
The maximum program time has been reached.
Read Drying takes too long in this chapter to find
out what to do.
L1
L2 Start
L3
Customer Care Center
1-800-898-1879
www.askona.com
Stop
15