Appendix B Factory Default List
B.3 Connectivity Management
Screen
Test Unit Ready Command
Settings
Sense Settings
Other Settings
■
Modify CA Reset Group
Screen
Select Ports
■
QoS
Screen
Enable/Disable QoS
*1:
The QoS function is disabled by default and only [Enable QoS] in [Action] is available.
■
Set FC/FCoE Host QoS
Screen
FC/FCoE Host QoS Setting
■
Set iSCSI Host QoS
Screen
iSCSI Host QoS Setting
■
Set SAS Host QoS
Screen
SAS Host QoS Setting
Setting item
Reservation Conflict Response
Notify Change Volume
Mapping
Notify Volume Capacity
Expansion
Notify Vendor Unique Sense
Sense Data Conversion
Command Monitor Time
Load Balance Response Status
iSCSI Discovery Reply Mode
iSCSI Reservation Range
Setting item
"Port" checkbox
Setting item
Operation mode
Setting item
Bandwidth Limit
Setting item
Bandwidth Limit
Setting item
Bandwidth Limit
1000
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
Default value
GOOD (Default)
Enable (Default)
Enable (Default)
Disable (Default)
No Conversion (Default)
Default (25 sec.)
CHECK CONDITION / UNIT ATTENTION (Default)
All - Reply All Ports (Default)
Storage System (Default)
Default value
All checkboxes are selected
Default value
Disable (*1)
Default value
Unlimited
Default value
Unlimited
Default value
Unlimited
P2X0-1270-13ENZ0