Basic Operation Information - Bosch ICP-EZM2 Installer's Manual

Easy Series (ICP-EZM2) | Installer Guide | 1.0 Quick Reference
1.3

Basic Operation Information

Item Description
House phone:
Outside phone:
Start and end a
phone session
Installer quick connect:
End a phone session:
Start a phone session (refer to options above).
Enter installer passcode when prompted.
Enter and exit
From the Installer Menu, press [3] for basic programming, or [4] for expert programming.
programming
-
-
To exit programming, press [#] repeatedly until you hear the system announce the Installer Menu options.
Options are four digits or six digits. Selection affects all passcode lengths.
Passcode length
Expert programming →Expert Programming Item Number 861.
Installer
Four-digit default = 5432; six-digit default = 543211 (Expert Programming Item Number 7011).
passcode
Master user
Four-digit default = 1234; six-digit default = 123455. (Expert Programming Item Number 7001).
passcode
In expert programming, enter Expert Programming Item Number 9999. Doing this restores all factory default
Factory default values. All programming items, except for the country code, are reset when you restore the factory default
values. All recorded speech items are unaffected.
Start a phone session, or press and hold [3] on the control center (refer to Section 1.2 Control Center
Overview on page 3).
Enter the master user passcode.
Add or change
users Press [4] to select the User Menu.
Press [1] to add a new user, or press [3] to change an existing user. Follow all voice prompts.
When you add a new user or change an existing user, you can also assign a token or key fob.
System Test On the control panel board, press the System Test button once to start the System Test.
Enter the installer passcode when you hear the "Call for Service" message.
"Call for
Service" Details
The system announces the system trouble condition and then asks you to select a menu option.
4
Press [#] three times, and enter a passcode.
Dial the house phone number, and press [*] three times when the call is
answered. Enter a passcode.
Connect a test telephone to the control panel's test posts or telephone
terminals. Press and hold the system test button for approximately 15 sec. Enter
a passcode.
Press [#] repeatedly until the system says "goodbye."
For Basic Programming, refer to Section 4.2 on page 30.
For Expert Programming, refer to Section 4.3 on page 36.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01