Wireless Maintenance; Wireless Configuration Menu - Bosch ICP-EZM2 Installer's Manual

Easy Series (ICP-EZM2) | Installer Guide | 3.0 Point Expansion
3.2

Wireless Maintenance

3.2.1

Wireless Configuration Menu

Use the Wireless Configuration Menu to:
•
Add new wireless devices to an existing wireless system
•
Add wireless devices that were not discovered when the wireless network was first discovered
•
Replace or delete wireless devices from an existing wireless system
To access the Wireless Configuration menu:
1. Start a phone session.
Refer to Section 1.3 System Setup on page 5 for phone session options.
2. From the Installer Menu, press [1] for System Maintenance.
3. From System Maintenance, press [6] for Wireless Configuration.
Refer to the following table for menu options and descriptions. Menu options are only available after the
initial device discovery and point test is completed.
Button Press Menu Option
[1] Replace a Device
[2] Add a Device
[3] Delete a Device
[4] Transfer Wireless Data
(control panel-to-hub)
[5] Transfer Wireless Data
(hub-to-control panel)
[6] Erase and Discover
[#] Exit Wireless Configuration
26
Description
Use this option to replace a known device with a new device.
1. Press [1] to replace a point, or [3] to replace an output.
For a relay module, select either the input or output, and then enter
the appropriate number in Step 2.
2. Enter the desired point number or output number.
The device discovery process starts.
3. When the system announces "Test all points," activate the new
device.
The new device replaces the current device. If other devices were
discovered in Step 2, they are returned to the undiscovered state.
Use this option to add more devices to the wireless network.
When you press [2] to select this option, the device discovery process
starts. When the system announces "Test all points," activate all of the
new devices.
If other devices were discovered but not activated, they are returned to
the undiscovered state.
Use this option to delete a known device from the system.
1. Press [1] to delete a point, or [3] to delete an output.
2. Enter the desired point number or output number.
If the selected point number corresponds with a relay module, both
the input and output are deleted from the system. If you only want
to delete the input or the output, you must disable the
corresponding function through programming.
3. Press [1] to delete the device.
The wireless hub deletes the device from the system, and the point
type or output function is set to 0 (Disabled).
If you replace a hub, select this option to send wireless data from the
control panel to the wireless hub.
If you replace the control panel, select this option to send wireless data
from the wireless hub to the control panel. This option deletes key fobs.
If the wireless data in the control panel does not match the wireless data
in the hub (Bus Device Trouble 50), use this option to erase the
wireless data in both the control panel and hub, and rediscover all
devices.
This option is only available if the wireless data does not match in the
control panel and hub.
Select this option to return to the System Maintenance options.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01