Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > stop host-lu-qos-performance
stop host-lu-qos-performance
This command stops the collection of Host-LU QoS performance information.
■
Syntax
stop host-lu-qos-performance [-port {
■
Parameter
-port
■
Example(s)
The following example stops the collection of Host-LU QoS performance information:
CLI> stop host-lu-qos-performance
The following example stops the collection of Host-LU Qos performance information for the specified ports:
CLI> stop host-lu-qos-performance -port 000,101
xyz
Optional. This parameter specifies the ports from which the Host-LU QoS performance
information is collected. Two or more parameters can be specified by separating them with a
comma (,).
Example: -port 000, 100
For more details, refer to
"1.2.15 Host Interface Port Syntax" (page
xyz
"x" is the controller module (CM) number, "y" is the CA module number, and "z" is
the port number.
Example: "123" indicates CM#1-CA#2-Port#3
all
All the ports
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
|all}]
346
29).
P2X0-1210-05ENZ0