Show Iscsi-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show iscsi-parameters

show iscsi-parameters

This command displays the parameters of each iSCSI host interface port.
■
Syntax
show iscsi-parameters [-port {
■ Parameter
-port
■ Output
CM# x CA# y Port#
Port Mode
Type
Host Affinity
iSCSI Name iSCSI name
Alias Name Alias to the iSCSI name
Host Response No.
Host Response Name
Reset Scope I_T_L (I: Initiator, T: Target, L: LUN) or T_L (T: Target, L: LUN)
Reserve Cancel at Chip Reset
port_numbers
Optional. This parameter specifies which iSCSI interface port on which information is to be dis-
played. Multiple comma-separated ports may be specified. If this parameter is omitted, the
information on all the iSCSI ports (excluding the virtual ports of the iSCSI ports) is displayed. To
display the information on the virtual ports, specify this parameter.
For details, refer to "1.2.15 Host Interface Port Syntax" (page
port_numbers
iSCSI interface port number in "
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the
iSCSI port number.
Example: 110 (CM#1, CA#1, iSCSI port#0)
all All iSCSI interface ports
z
Port number
Port mode
Module type (1G iSCSI, 10G iSCSI, or iSCSI-RA)
Host affinity mode (Enable: enabled, Disable: disabled)
Host response number
Host response name
Indicates whether reservations are canceled when a host interface port is reset (Enable: can-
celed, Disable: not canceled).
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
| all}]
xyz
" format
234
29).
P2X0-1210-05ENZ0