System Data Control; Pc Programming - Panasonic KX-TDA100 Features Manual

2.3

System Data Control

2.3.1

PC Programming

Description
Although many PBX features can be programmed using a proprietary telephone (PT) (→ 2.3.2 PT
Programming), a PC connected to the PBX can use the KX-TDA Maintenance Console software to program
in further detail. System programming, diagnosis, and data upload/download can be performed either
through on-site programming or remote programming.
1)
On-site Programming: Programming that is performed using an on-site PC connected directly to
the PBX.
2)
Remote Programming: Programming that is performed using an off-site PC that connects to the
PBX via a CO line.
1.
Connection Methods for On-site Programming
Method
Serial Interface
(RS-232C port)
USB
LAN
Modem
(connected to SLT
port)*
ISDN TA
(connected to ISDN
extension line)*
* Remote access must be enabled through system programming (→ Remote Programming [810])
when performing on-site programming via modem or ISDN TA.
Description
The PC is connected to the PBX via the Serial Interface
(RS-232C port) of the PBX.
The PC is connected to the PBX via the USB port located
on the MPR card, or to the USB port of a USB Module
attached to a digital proprietary telephone (DPT).
The PC is connected to the PBX via Ethernet cable to the
CTI-LINK card.
The PC is connected to a modem, which is then connected
to an SLT port of the PBX. Use the modem to dial the
floating extension number assigned to the analog remote
maintenance feature (→ Modem Floating Extension
Number [811]) to access the PBX.
The PC is connected to an ISDN terminal adapter (TA),
which is then connected to the PBX via an ISDN extension
line. Use the TA to dial the floating extension number
assigned to the ISDN remote maintenance feature. (→
ISDN Remote Floating Extension Number [812])
2.3 System Data Control
Required
Hardware
—
MPR card
(preinstalled) or
USB Module
CTI-LINK card
RMT card and
user-supplied
modem
User-supplied
ISDN TA which
supports CAPI
Feature Guide 245