Table of Contents
Advertisement
Warning and Safety instructions
See "Installation" and "Technical data".
The accessibility of the plug must be always ensured, in order to
separate the tumble dryer from the mains. All electrical work should
be carried out only by a suitably qualified and competent person, in
strict accordance with national and local safety regulations.
If the appliance is hard wired, adequate provision must be made
on site to switch off all poles to disconnect the tumble dryer from the
electrical supply.
Do not block the gap between the bottom of the tumble dryer and
the floor with plinth facings, deep pile carpet etc. This would hinder a
sufficient flow of air to the dryer.
Do not install a lockable door, a sliding door or a door which is
hinged in the opposite direction to the dryer door.
This tumble dryer is supplied with a special lamp to cope with par-
ticular conditions (e.g. relating to temperature, moisture, chemical
resistance, abrasion resistance and vibration). This special lamp must
only be used for the purpose for which it is intended. It is not suitable
for room lighting. Replacement lamps may only be fitted by a Miele
authorised person or by Miele Service.
Information on the heat pump and refrigerant
- This tumble dryer uses refrigerant gas which is not flammable and
not explosive.
- The humming noises caused by the heat pump during the drying
process are normal. They do not impair the efficient functioning of
the tumble dryer.
Damage to the tumble dryer by switching it on too soon.
This can damage the heat pump.
After setting up the tumble dryer, wait for at least one hour before
switching it on.
- This tumble dryer contains fluorinated greenhouse gases (F-Gas).
They are hermetically sealed.
Designation of refrigerant: R134a
10
Advertisement
Table of Contents
