Yamaha VMAX VMX17 Owner's Manual page 70

PERIODIC MAINTENANCE AND ADJUSTMENT
7. Install the final gear case breather
cap by installing the washer and
bolt, and then tighten the bolt to the
specified torque.
Tightening torque:
Final gear case breather cap bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
To change the final gear oil
1. Place the vehicle on a level sur-
face.
2. Place an oil pan under the final
gear case to collect the used oil.
3. Remove the final gear case
6
breather cap by removing the bolt
and washer.
1
2
3
4
5
1. Final gear case breather cap bolt
2. Washer
3. Final gear case breather cap
4. Final gear oil filler bolt
5. Gasket
4. Remove the final gear oil filler bolt,
the final gear oil drain bolt and their
gasket to drain the oil from the final
gear case.
6-15
1
1. Final gear oil drain bolt
2. Gasket
5. Install the drain bolt and its new
gasket, and then tighten the bolt to
the specified torque.
Tightening torque:
Final gear oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
6. Remove the final gear oil check
bolt and its gasket.
2