3. Push "SELECT" to highlight "Stop-
watch".
4. Push "RESET".
The multi-function display chang-
es to the Normal mode and the
stopwatch is displayed in place of
the clock.
5. Push "SELECT" to start the stop-
watch.
6. Push the start switch "
LECT" to stop the stopwatch.
7. Push "RESET" to reset the stop-
watch.
TIP
●
If neither "SELECT" nor "RESET"
are pushed for one minute, the
screen automatically changes to
the Normal mode.
INSTRUMENT AND CONTROL FUNCTIONS
●
Pushing "RESET" for at least two
seconds changes the screen to
the Normal mode.
●
To perform further multi-function
display settings, enter the Select
mode again by pushing and hold-
ing "SELECT" and "RESET" for at
least three seconds.
Using the countdown clock
The countdown clock can be activated
as follows.
1. Push "SELECT" to highlight "Stop-
watch".
2. Push "RESET".
3. Push
"SELECT"
"Countdown".
" or "SE-
4. Push "RESET". The multi-function
display changes to the Normal
mode, the stopwatch is displayed
in place of the clock, and the trans-
mission gear indicator changes to
the countdown clock.
5. Push "SELECT" or shift into gear
to
highlight
6. Push the start switch "
7. Push "RESET" to reset the count-
8. Repeat steps 5–7, or push "RE-
TIP
To perform further multi-function dis-
play settings, be sure the transmis-
sion is in neutral, then enter the
3-14
and the countdown clock starts
counting down from "5". Simulta-
neously, the shift timing indicator
light flashes according to the num-
ber displayed (i.e., when "5" is dis-
played, the indicator light flashes
five times, when "4" is displayed,
the indicator light flashes four
times, etc.). The stopwatch starts
counting when the countdown
clock finishes counting.
" or "SE-
LECT" to stop the countdown
clock.
down clock and stopwatch.
SET" again for at least two sec-
onds to enter the Normal mode.
3