Yamaha YZ250 2022 Owner's Service Manual page 57

1. Ignition coil lead
2. Clamp
3. CDI magneto lead
4. Neutral switch lead
5. Radiator breather hose
6. YPVS breather hose
7. Connector cover
A. Clamp the ignition coil lead to the frame at its
locating tape. Clamp it in front of the radiator
fitting boss.
B. Clamp the CDI magneto lead to the frame at
its locating tape. Clamp it at the rear of the
radiator fitting boss.
C. Do not allow the neutral switch lead to
slacken except over the radiator hose.
D. Pass the neutral switch lead through the
holder.
E. Pass the radiator breather hose outside the
engine bracket and inside the down tube.
Then pass the radiator breather hose inside
the CDI magneto lead.
F. Clamp the CDI magneto lead, radiator
breather hose, YPVS breather hose and neu-
tral switch lead to the frame.
G. Clamp the radiator breather hose, CDI mag-
neto lead and neutral switch lead to the
frame.
H. Pass the CDI magneto lead, radiator breather
hose and neutral switch lead in front of the
radiator hose. Then pass the radiator
breather hose inside the CDI magneto lead
and neutral switch lead.
I. Pass the radiator breather hose and ignition
coil lead between the frame and the radiator
(left).
J. Locate the clamp ends in the arrowed range.
K. Bring the connector cover into contact with
the coupler.
CABLE ROUTING DIAGRAM
2-18