Yamaha YZ250 2022 Owner's Service Manual page 224

5. Install:
• Pilot jet "1"
• Main jet "2"
6. Install:
• Needle valve "1"
• Float "2"
• Float pin "3"
TIP
• After installing the needle valve to the float, in-
stall them to the carburetor.
• Check the float for smooth movement.
7. Install:
• Float chamber "1"
• Plate "2"
• Screw (float chamber) "3"
8. Install:
• Air vent hose [L = 580 mm (22.8 in)] "1"
• Air vent hose [L = 400 mm (15.7 in)] "2"
• Overflow hose [L = 280 mm (11.0 in)] "3"
• Clamp "4"
Refer to "CABLE ROUTING DIAGRAM" on
page 2-15.
TIP
Install the air vent hoses and overflow hose to
the carburetor with their ends not having the cuts
"a" toward the carburetor.
9. Install:
• Jet needle "1"
• Collar "2"
• Spring "3"
• Jet needle holder "4"
(to the throttle valve "5")
TIP
Install the spring with its smaller dia. "a" facing
the collar.
10.Install:
• Throttle cable "1"
• Locknut "2"
Locknut (throttle cable carburetor
side)
4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
• Mixing chamber top "3"
• Spring (throttle valve) "4"
• Ring "5"
• Throttle valve "6"
TIP
• While compressing the spring, connect the
throttle cable.
• Align the projection "a" on the ring with the
groove "b" in the jet needle holder "7".
7-9
CARBURETOR