Yamaha YZF R1 2020 Owner's Manual page 27

Pass/LAP switch " /LAP"
Press this switch to flash the head-
lights and to mark the start of each lap
when using the lap timer.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU66091
Horn switch "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
EAU12402
set this switch to "
the switch down towards "
page 7-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch "OFF/ "
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
EAU66040
used in case of an emergency or to
"
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
". When
The hazard lights can be turned on or
off only when the key is in the "ON" po-
sition. You can turn the main switch to
the "OFF" or "LOCK" position, and the
hazard lights will continue to flash. To
Instrument and control functions
turn off the hazard lights, turn the main
EAU66030
"
switch to the "ON" position and oper-
ate the hazard switch again.
EAU66061 NOTICE
/ / "
Do not use the hazard lights for an
", and then push
extended length of time with the en-
". See
gine not running, otherwise the bat-
tery may discharge.
" to stop the en-
Mode switch "MODE"
Use the mode switch to change YRC
modes or edit the PWR, TCS, SCS,
and EBM settings from the main
screen. This switch has three buttons.
EAU88272
Up button - push this button to chan-
ge the selected YRC setting upward.
Center button - push this button to
scroll left to right among the MODE,
PWR, TCS, SCS, and EBM items.
Down button - push this button to
change the selected YRC setting
downward.
TIP
 The center button is also used to
5-3
activate the launch control sys-
tem. When the LCS icon is grey,
push and hold the center button.
ECA10062
5
EAU88400