Table of Contents
Advertisement
To activate an alarm
1
Android device: Open the Smart BT Speaker application.
2
Tap SETTINGS > Alarm.
3
Drag the slider beside the desired alarm to the ON position.
To deactivate an alarm
1
Android device: Open the Smart BT Speaker application.
2
Tap SETTINGS > Alarm.
3
Find the alarm that you want to deactivate, then drag the slider to the OFF
position.
To delete an alarm
1
Android device: Open the Smart BT Speaker application.
2
Tap SETTINGS > Alarm.
3
Press and hold the alarm that you want to delete, then tap OK.
Setting your device to move around
The BSP60 speaker has two action settings that control how it responds by
movement to your voice or to music. The default action setting is React to Voice.
When this setting is enabled, your BSP60 speaker reacts to voice commands and
makes small movements. If you want the BSP60 speaker to dance in time to music,
you can enable the Dance with music setting. Each dance routine to music lasts a
maximum of 7 minutes. Both action settings can be enabled at the same time.
To enable movement actions
1
Android device: Open the Smart BT Speaker application.
2
Tap SETTINGS > Action.
3
Select React to Voice or Dance with music, or both, depending on your
preferred action, then drag the slider beside the desired action to the ON
position.
4
Tap TURN ON.
Before you enable a movement action, make sure that no USB cable is connected. For other
usage tips, see
Guidelines for using the "Dance with music" action .
Guidelines for using the "Dance with music" action
When the "Dance with music" action is enabled, avoid using the BSP60 speaker in
the following environments:
•
Uneven places or unstable places subject to vibrations
•
Slippery surfaces
•
Thick carpets
•
Soft surfaces, such as bedding
•
Places subject to soil, sand, or dust
•
Wet places with water or oil present
•
Outdoors
•
Inside cars
To avoid the BSP60 speaker from dropping to the ground from a higher surface or getting
otherwise damaged when you use the "Dance with music" action, make sure that the device
has a total available free space around it of 30 cm squared. The BSP60 speaker normally goes
back to its original position after a "Dance with music" routine. Note, however, that the BSP60
speaker does not go back to its original position if you perform any action during the routine
that uses the BSP60 speaker directly, for example, if you stop music playback by pushing
down one of the speaker covers. The BSP60 device is not equipped with an anti-drop sensor.
Also, make sure that no USB cable is connected.
This is an Internet version of this publication. © Print only for private use.
11
Advertisement
Table of Contents
